MIL-G-80048C
In this specification, all measurements,
be as specified (see 6.2.1).
dimensions, sizes and capacities are given in the U.S. Customary System of
These measurements may be converted to the International
Units (US).
System of Units (SI) through the use of the conversion factors and methods
specified in ANSI/IEEE 268.
Means shall be provided for lubrication of all
3.2.5 Lubrication.
Recirculating systems, when provided, shall
sliding and moving parts.
Each lubricant-
include filters which are cleanable or replaceable.
reservoir shall have means for determining the fluid level. All oil holes,
grease fittings and filler caps shall be readily accessible.
3.2.6 Interchangeability. . To provide for replacement of worn parts, all
parts shall be manufactured to definite dimensions and tolerances which
will permit installation of replacement parts without modification of part
or machine.
3.3 Construction. The machine shall be constructed of parts which are
The structure shall be
new, without defects and are free of repair.
capable of withstanding all forces encountered during the operation of the
machine to its maximum rating and capacity without permanent distortion.
3.3.1 Casting and forgings. All castings and forgings shall be free of
NO process such as peening, plugging or filling
scale and mismatching.
with paste shall be used for reclaiming any defective part.
Welding, brazing or soldering
3.3.2
Welding, brazing or soldering.
None of
shall be employed only where specified in the original design.
these operations shall be employed as a repair measure for any defective
part.
3.3.3 Fastening devices. All screws, pins, bolts and other fasteners
shall be installed in a manner to prevent change of tightness. Fasteners
that are subject to removal or adjustment shall not be swaged, peened,
staked or otherwise permanently installed.
3.3.4 Surfaces. All surfaces shall be cleaned and free of sand, dirt,
fins, sprues, flash, scale, flux and other harmful or extraneous materials.
All edges shall be either rounded or beveled unless sharpness is required
to perform a necessary function. Except as otherwise specified herein, the
condition and finish of all surfaces shall be in accordance with the
manufacturer's standard commercial practice.
3.3.5 Painting.
Unless otherwise specified (see 6.2.1), the machine
shall be painted in accordance with the manufacturer's standard commercial
practice.
3.3.6 Threads. All threaded parts used on the machine and its related
attachments and accessories shall conform to FED-STD-H28 and the applicable
detailed standard section referenced therein.
3.3.7 Plates. All words on instruction and indicating plates shall be
in the English language. Characters shall be engraved, etched, embossed or
stamped in boldface on a contrasting background.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business