MIL-G-80048C
6.4 Safety and health requirements. Paragraph 3.2.4 requires compliance
only with those OSHA requirements that concern the machine itself. It does
not require compliance with OSHA requirements that concern "the machine in
its operating `environment" such `as noise levels, radiation levels,
electromagnetic emissions, noxious vapors, air contaminants, heat, etc.
Since OSHA limits the total hazard level of these hazard levels in the
proposed operating environment, and specify additional machine requirements
that will integrate the new machine into its future operating environment.
If specific point-of operation guarding is required, the procuring agency
should specify the exact configuration of the guard required, as in most
cases, the guard configuration is dependent on the size and configuration
of the workplaces. The above, and any other additional safety and health
requirements should be specified in detail under 6.2.1.
6.5
Changes from previous issue.
Astericks are not used in this
revision to identify changes with respect to the previous issue due to the
extensiveness of the changes.
6.6 Cross-reference of classification changes.
Machine classification
changes from the previous issue of this specification are as follows:
MIL-G-80048B
MIL-G-80048C
Size 1
Size 1
Size 2
Size 2
Size 3
Size 3
Size 4 (New Size)
Custodians:
Preparing Activity:
AL-(39
IP
Reviewing Activities:
Project Number
GS-84-AL
3415-0119
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business