MIL-G-80267
arranged and mounted convenient to and in full view of the operator. An
emergency stop switch shall be furnished on the control station.
Covers, guards, or other safety
3.1.5 Safety and health requirements.
devices shall be provided for all parts of the machine that present safety
The safety devices shall not interfere with the operation of the
hazards.
The safety devices shall prevent unintentional contact with the
machine.
guarded part and shall be removable to facilitate inspection, maintenance
All machine parts, components, mechanisms, and
and repair of the parts.
assemblies furnished on the machine, whether or not specifically required
herein, shall comply with ANSI B11.9 and with all of the requirements of
OSHA 2206 that are applicable to the machine itself. In the event of a con-
flict between the requirements of the ANSI and OSHA standards, the OSHA
Additional safety and health requirements shall be
standards shall apply.
as specified (see 6.2.1).
The machine shall not contain mercury or
Mercury restriction.
3.1.6
mercury compounds nor be exposed to free mercury during manufacture.
3.1.7 Asbestos restriction.
Asbestos and materials containing asbestos
shall not be used on or In the machine.
3.1.8 Environmental protection.
The machine shall be designed and con-
structed such that, under the operating, service, transportation and storage
conditions described herein, the machine shall not emit materials hazardous
to the ecological system as prescribed by Federal, state or local statutes
in effect at the point of the installation.
3.1.9 Interchangeability. To provide for replacement of worn or damaged
parts, all parts shall be manufactured to definite dimensions and tolerances
that will permit installation of replacement parts without modification to
the part or the machine.
3.2 Construction.
The machine shall be constructed of parts which are
new, without defects, and free of repairs. The structure shall be cable of
withstanding all forces encountered during operation of the machine to its
maximum rating and capacity without permanent distortion.
Castings and forgings.
All castings and forgings shall be free
3.2.1
Processes such as welding,
from defects such as scale and mismatching.
peening, plugging, or filling with solders or pastes shall not be used on
machine. Such processes may be used on castings or forgings to reclaim any
Such processes may be used
defective components for use on the machine.
only for enhancing surface finish and appearance.
3.2.2
Welding, brazing, or soldering
Welding, brazing- or soldering.
None of
shall be employed only where specified in the original design.
these processes shall be employed as a repair measure for any defective
part.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business